A furnace that won't light or keeps shutting off needs real diagnosis, not another reset. A CO check happens on every call, standard, not an upsell.
A short list of components causes most Furnace Repair calls: ignitor, flame sensor, gas valve, heat exchanger. Each gets tested with a multimeter and combustion analyzer, not replaced on a hunch, not parts-cannon guessing.
What doesn't change from visit to visit.
Every repair includes a CO check, not optional.
No-heat calls in Slaughter get priority routing over routine work during cold snaps when it's cold.
Ignitor or heat exchanger, the price is quoted and approved before work begins.
Our techs are trained equally on gas furnaces and electric heat strips, no exceptions.
Six repairs that cover most of our winter calls.
These two parts are behind most no-heat visits, usually a same-visit fix.
We test actual response and pressure output rather than replacing an expensive part on a hunch before we recommend replacing it.
A cracked heat exchanger can leak combustion byproducts into the airflow — we inspect with a scope and analyzer rather than assuming based on age.
Short-cycling or mid-cycle shutdowns often trace to the limit switch or a struggling blower before condemning the control board.
Older Slaughter furnaces with standing pilots have their own failure points — thermocouples, pilot orifices, draft issues that newer ignition doesn't have.
Zero response from the furnace can mean a wiring fault, not a furnace failure to avoid overcharging for parts you don't need.
Four steps, safety checked at every one.
Tell us what the furnace is doing and we'll get someone moving.
Truck arrives stocked with common ignitor, flame sensor, and control parts ready to diagnose and often repair same visit.
Combustion analysis happens before any repair is quoted, then a flat-rate quote.
We re-check CO before signing off, backed by warranty.
Recent reviews from winter heating calls.
Pilot light kept going out on our older furnace every few days. Tech identified a failing thermocouple that two other companies had overlooked.
— H. Delacroix, homeowner
Furnace made a loud bang on startup that scared the whole family. Turned out to be a delayed ignition issue from a dirty burner, cleaned and resolved same visit.
— F. Ibekwe, homeowner
Called about a gas smell near the furnace closet and they had someone here within the hour to confirm it was safe before doing any repair work.
— Q. Whitmore, homeowner
Landlord here with an older building, they've kept three separate furnace units running through two winters without a single emergency callout.
— Z. Andreou, landlord
What Slaughter customers ask most.
We always confirm with a proper reading before quoting.
It's a real safety concern, taken seriously.
A CO check is standard on every call, no upcharge.
We still service these older systems.
No-heat calls get priority routing, usually same-day even during high demand.
Uncommon parts might mean a follow-up visit to finish the repair.
We dispatch heating techs throughout Slaughter — call to confirm.
Confirm Coverage
